If you want to strip the old piano finish without removing patina, then the gentle method is the way. This is only for pianos that have original finish and no paint over that.   

The old finish is shellac. It will melt off with denatured alcohol or methanol. I will tell you my old method. Slop methanol on the surface liberally with a brush. Cover the surface with waxed paper from the grocery store. Leave it until the finish has softened (10-15 min.). The old finish can be shoveled off with a plastic spatula or squeegee. When it is clean you can wet it further and keep cleaning it off with rags saturated in methanol.  

You do not want to remove all the finish but only the top several coats. The bottom coat must stay so don't keep putting fresh solvent on after it is mostly clean. I do not like steel wool as it leaves tiny rust spots inside new finishes many times, as it breaks off tiny metal pieces.  Use green pad Scotch brite or the cheaper ones found at Oriental grocery stores. 

At the point when it is clean of thick coats of shellac I dry it, do a fine sanding and go back with new orange or "Amber" shellac, as they now call it. Once the color of the wood is as dark as you want it, then change to clear shellac. Behlen makes some very nice "blonde" shellac flakes. That is the best clear I have found. The best way to buy shellac is in flake form and mix it yourself with methanol. (It has to sit overnight to dissolve the flakes.)  

Once you begin working with shellac you will come to prefer it. Once you get a good buildup of shellac you can French polish it to the original mirror finish. It will then be as it was originally.  

French polish is not a substance but a technique. The ingredients are shellac, solvent, and linseed oil and most important--the right rag.  

This stripping technique will be slower than the big commercial methods. However, you avoid the bleaching, washing, staining, and sealing steps so it is often faster than what everyone has been brainwashed into doing by the big chemical companies.  

By the way, if methanol does not strip fast enough you may mix 50-50 methanol and lacquer thinner and get your basic gentle but slightly stronger stripper. The old guys used to also add some acetone if the finish was particularly stubborn.  And they would shave blocks of paraffin into it to make the paste type for slower dry time

Doug L. Bullock, Originally written in 1998 updated 2009 Copyright 1998-2009
  

Back to top